This Is A 3/4 Ounce Bottle Of Bob Smith Industries Insta-Cure+ Gap Filling Pocket Ca Glue With A Pin In Cap Lid. Insta-Cure+ Gap Filling Ca Glue. Insta-Cure+ Is A Higher Viscosity Ca For Loose Fitting Joints In Which The Adhesive Must Bridge Gaps. Normally The Thicker Ca Is Applied To One Surface And Then The Parts Are Held Tightly Together For About 5 To 15 Seconds. For Large Surface Areas Including Those With Close Fitting Joints Such As Laminations Insta-Cure+ Should Also Be Used. To Prevent Premature Curing Dont Spread The Glue Into A Thin Film. Lay Down A Serpentine Bead With About 1"" Separations On One Surface Then Assemble The Parts Letting The Pressure Spread The Ca Out. The Pocket Cas Feature A New Top That Has A Pin Built Into The Cap That Covers The Nozzle. This Pin Seals The Bottle So That If It Is Tipped Over The Bottle Will Not Leak. This Makes The Pocket Cas Ideal For Keeping In Your Tool Or Field Box.
Actual product packaging and materials may contain more and/or different information than that shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product.
For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. ZiFiti does not assume liability for inaccuracies or misstatements about products.
Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
