Instructions Simply Drill 3/8"" Hole Insert Cutting Head And Compress Handles. Gives You The Ability To Make Square Holes For Fuse Holders, Special Connectors Displays Etc. Material To Be Nibbled Is Placed In The Gap Between The Punch And Blade Channel. By Squeezing The Handles Together, The Punch Will Move Down Into The Channel, Cutting Out A Slug Of Metal. A Scribe Line Can Be Followed By Looking Down On Work In This Position. A Slot Is Cut By Making Successive Cuts. To Make A Sharp 90 Degrees Turn, Pull The Tool Out Of The Slot. Turn The Work 90 Degrees And Insert The Tool Again. By Turning The Tool Before Each Cut, A 5/16"" (7.9Mm) Minimum Radius Can Be Cut. Almost Any Size
Actual product packaging and materials may contain more and/or different information than that shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product.
For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. ZiFiti does not assume liability for inaccuracies or misstatements about products.
Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
![HSS Aircraft Extension Drill Bit [Set of 2] Size: 31/64" x 12"](/images/itemImgMed/48757/48757_4515970.jpg "HSS Aircraft Extension Drill Bit [Set of 2] Size: 31/64\" x 12\"")
