The Hair Pulling Task Of Removing Wheel Bearings Has Been Made Easier!Removes Bearings Without Damaging Wheels.Works On Virtually Any Sized Motorcycle Wheel Bearing.Safe And Easy.The Set Consists Of 7 Removers-25Mm, 20Mm, 19Mm, 17Mm, 15Mm, 12Mm And 10Mm; Plus 2 Rods To Fit All Bearing Sizes With Storage Case.Each Remover Has A Tapered End So Part Of The Remover Will Slip Inside The Bearing...Simply Put The Proper Size Remover In The Bearing, Then Flip Wheel &Amp;Amp; Bearing Over So The Remover Is Against The Floor. Next Take The Rod Tool And Insert Into Remover And Tap Firmly Into Place (The Remover Has A Slot In It For The Rod Tool To Slide Into). Once You Have The Rod Firmly In Place Simply Lift The Wheel And Bearing Off The Ground And Tap Again And The Bearing Will Fall Out. When The Remover Is Against The Ground And Taped On, It Is Spread Apart Tight Against The Bearing, Then When You Lift Off The Ground And Tap, It Pushes The Bearing Out Of The Race. You Will Be Able To Remove Bearings In Seconds With This Tool.Manufacturer Offers Lifetime Warranty On This Tool.
Actual product packaging and materials may contain more and/or different information than that shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product.
For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. ZiFiti does not assume liability for inaccuracies or misstatements about products.
Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
