Pla 3D Printer Filament Is The Most Basic The Most Used Filament No Clog No Bubble No Tangle Sunlu Pla Filament Has Good Layer Adhesion Very Easy To Use Recommend Settings Nozzleextrusion Temperature: 200-230 Bedplatform Temperature Of 50-65 Printing Speed: 50-100Mms These Settings Are For 04Mm Nozzle It May Be Different With Different Diameters Nozzle 3 Steps Checking: Why Is The Filament Not Sticking To The Build Bed Temperature Checking - Please Check The Temperature(Bed And Nozzle) Settings Before Printing And Set It Suitable Building Bed Checking - Please Check If The Bed Is Level Make Sure The Nozzle Doesnt Too Far Or Too Close To The Bed Speed Checking - Please Check If The Printing Speed Of The First Layer Is Too Fast Notes Please Insert The Filament Into The Side Holes After Use To Avoid Tangles Please Store The 3D Printer Filament In A Sealed Bag Or Box After Using It
Actual product packaging and materials may contain more and/or different information than that shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product.
For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. ZiFiti does not assume liability for inaccuracies or misstatements about products.
Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
