The Difficulty Of Replacing The Micro-Movement Is To Remove The Old Micro-Movement It Is Recommended To Use The Tin Sucker With To Remove The Solder. Heating Welding Time As Short As Possible Each Soldering Time Is Controlled Within 1-3 Seconds To Prevent Excessive Temperature Damage To The Circuit Board And The Micro Switch. Micro Switch Should Be Close To The Circuit Board There Can Not Be Any Gaps. Otherwise It Is Easy To Cause Problems Such As Shortening The Stroke And Bad Feel. Finally Check That There Are Residual Tin Slag Left On The Board To Avoid Short Circuit.
Actual product packaging and materials may contain more and/or different information than that shown on our website. We recommend that you do not solely rely on the information presented and that you always read labels, warnings, and directions before using or consuming a product.
For additional information about a product, please contact the manufacturer. Content on this site is for reference purposes and is not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. ZiFiti does not assume liability for inaccuracies or misstatements about products.
Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
